9号彩票官网

Notice of stainless steel products

Stainless steel is in the air or chemical corrosion medium can resist the corrosion of a high alloy steel, stainless steel is beautiful surface and has good corrosion resistance, need not through surface treatment such as plating color, and play so inherent surface properties, used in the iron and steel, commonly known as stainless steel.
Earth kitchen stainless steel products is higher than the general strength of the material, so the punching and shearing need higher pressure, and the knife and the knife gap is accurate can not occur shear failure and work hardening, the best use of plasma or laser cutting.
When to use gas cutting or arc cutting, the heat affected zone of grinding and the necessary heat treatment. Stainless steel is in the air or chemical corrosion medium can resist the corrosion of a high alloy steel, stainless steel is beautiful surface and has good corrosion resistance, need not through surface treatment such as plating color, and play so inherent surface properties, used in the iron and steel, commonly known as stainless steel.
Stainless steel products processing should pay attention to the following points:
1 stainless steel processing speed should slow down, slow down the feed rate, the general line speed of not more than 130
2 coolant should be water soluble cutting fluid, semi synthetic, cooling, lubrication is good.
3 stainless steel although hard but it also cotton, that is the meaning of soft. All of the above will be stirred up. To grind to stainless steel processing tools. Turning angle is greater than 5 in this way can play a lot of engagement, the efficiency will be high. General knife edge 3MM.
4 because the stainless steel is easy to deform, drilling and tapping is very difficult, so to prevent overheating, in the processing surface injection.
5 in stainless steel welding should pay attention to the size of the welding current.
6 because in the process of cutting tool surface and other non metal or metal combined into the alloy, so that the tool is more likely to rust, I think you can add an anti oxide film or anti oxide film.
7 lathe stainless steel processing set and use YT8 lane.
8. Should pay attention to not let has a very strong corrosive magnetic and stone luxury clean drug exposure to stainless steel surface, if the contact should imtely wash. After the construction, the application of neutral detergent and water washing a surface for the attachment of cement, fly ash matter.
Hits:  UpdateTime:2016-08-03 10:06:37
友情链接:金福彩票官网  聚富彩票  鸿利彩票网  聚富彩票网  聚富彩票  鸿利彩票网  大发彩票  

免责声明: 本站资料及图片来源互联网文章,本网不承担任何由内容信息所引起的争议和法律责任。所有作品版权归原创作者所有,与本站立场无关,如用户分享不慎侵犯了您的权益,请联系我们告知,我们将做删除处理!